Management

Support system for conveyor belt sag

{{image2-a:r-w:270}}The K-Sure system, which does not require any pre-engineering, adjustments or special tools, is designed to provide consistent, stable support for troughed belt profiles by reducing the number of rotating components in the conveying system.

Kinder’s K-Sure solution increases skirting seal effectiveness by addressing conveyor belt edge sag, which can occur when too few idlers have been installed at the loading point.

The K-Sure system corrects this issue by utilising existing conveyor idler frames and load carrying the centre conveyor roller. The wing rollers are then replaced by the system’s universal adaptor brackets and low friction polymer belt support rails. These come in standard 2m length assembly kits, with other lengths available upon request.

The K-Sure system can also be used in combination with Kinder’s K-Containment and K-Snap-Loc dust seal products for even greater bulk material control.
 

Watch video

Leave a Reply

Send this to a friend